Gold Dehancer Pro OFX 7.1.0 [K] MAC ***UPDATED

Didn't work for me on M1 MacBook Pro Ventura 13.4.1 Davinci Resolve 18.5. On first launch Davinci Resolve crashed immediately. Afterwards Dehancer 7 not available in Effects, only previously installed Dehancer Pro 6.3.0
Installing without replacing enhancerProMetal_arm64_x86_64_v7. ofx inside the plugin lets Dehancer Pro 7 run in trial mode.

 

Hello,Snook what version is your DaVinci? I suspect it's not 18.5 that can't be used

 

We are both using 18.5 Studio.

 

I am also 18.5. So I think it may be a problem with this version

 

I'm sure, I used davinci 18 with intel chips. It works fine. It's the davinci version that's causing the crash

 

18.1
Can be used normally

 

18.5 with Dehancer Pro 6.3.0 works fine. I would rather a working Resolve 18.5 with Dehancer 6.3.0 combo than 18.1 with Dehancer Pro 7.
Hopefully a working DP7 comes around at some point

 

Hello guys, Sorry I actually did not get to test it myself, just was passing a long the share.
I will update the info on the original post.

 

It works fine on Intel chips, but 18.1 still doesn't work on m chips

 

After many repeated confirmations, the Intel chip mac. DaVinci 18.5 can work normally, but it cannot work on the M chip MAC computer DaVinci 18.5

 

Can you clarify: are you saying Dehancer Pro 7 Inside Davinci Resolve 18.5 works on Intel but not M1?

 

All I can tell u is that I tested it on an old Mac with an Intel i3 chip. Da Vinci version is 18.5. dehancer version 7.0 is ready to run

 

That's very useful. Thanks for letting the group know.

 

DR 18.5.1 is out now, perhaps some one can test it on that version, I guess we still don't know if its "Davinci bug" or "Dehancer bug"?

 

*** UPDATE Now working
***New link in the first post it is with a Hex Edit you need to do but I can confirm it is working perfectly

 

now working on M1 and Davinci 18.5.1

 

Need to override and enter the code later? Or just enter the code after installation?

 

install 7, do the Hex fix and done, I had to save the Hex file to my desktop then replace it with the original
'/Library/OFX/Plugins/DehancerProMetal_arm64_x86_64_v7.ofx.bundle/Contents/MacOS/DehancerProMetal_arm64_x86_64_v7.ofx'
Depends what Hex editor you use, Some use HexFein, which did not work for me and I used 10Hexeditor which worked for me, It would not allow me to saved the file to the original folder so I saved it to my desktop and just replaced it and it works perfectly fine..
A lot of cool new features with 7 over 6.3 by the way

 

So far I still have no success. I have updated to 18.5.1. I may have to research